High-frequency isolated variable frequency speed regulation sensorless vector control in mine
-
摘要: 在煤矿中、高压及有限场合,变频器采用工频变压器接入电网且被控电动机大多采用开环控制,存在工作空间狭小、结构复杂和电动机控制鲁棒性差等问题。针对上述问题,提出了一种基于高频隔离型变频调速拓扑结构的无速度传感器矢量控制策略。对矿用高频隔离型变频调速主电路拓扑及功率传输进行了分析:通过不可控整流环节将输入的三相工频交流电源整流为直流电源,将脉动直流电源进行平滑滤波处理,得到稳定的直流电源,经高频隔离DC−DC级进行变压,然后经三相逆变级将直流电源逆变为电压和频率均可调的交流电源。为减少IGBT开关损耗、节约整体成本并减少其整体结构复杂性,三相整流级采用二极管不控整流策略;高频隔离DC−DC级采用等脉宽调制策略(EPWM);三相逆变级采用无速度传感器矢量控制策略,在该控制策略中采用模型自适应系统(MRAS)进行异步电动机速度估测。采用0.75 kW的三相异步电动机作为被测电动机,对矿用高频隔离型变频调速无速度传感器矢量控制策略进行实验验证,结果表明:① 高频隔离DC−DC级两侧直流母线电压波动小于10 V且高频方波电压相等,原边单相逆变方波和高频变压器耦合方波电压波形平滑,整体稳态性能好。② 三相逆变级电压、电流波形正弦度良好,波形对称且光滑度较好,三相逆变级稳定性能好,满足电动机运行要求。③ 随时间增加,励磁电流变化较稳定,转矩电流在启动时响应迅速,且启动阶段转矩电流较大,能产生较大的转矩。④ 电动机速度稳定阶段速度波动小,加、减速阶段波形趋于一次函数,电动机能够平稳启停。电动机在刚启动时最大转矩可达到稳定转矩的5倍以上,能够较快启动进行工作。
-
关键词:
- 高频隔离型变频器 /
- 变频调速 /
- 无速度传感器矢量控制 /
- 模型自适应 /
- 异步电动机 /
- 逆变级 /
- 高频隔离DC−DC级 /
- 整流级
Abstract: In the coal mine's medium and high voltage and limited occasions, the frequency converter is connected to the power grid by power frequency transformer. Most of the controlled motors are controlled by open-loop control, which has the problems of narrow working space, complex structure and poor robustness of motor control. In order to solve the above problems, a speed sensorless vector control strategy based on high frequency isolated variable frequency speed regulation topology is proposed. This paper analyzes the topology and power transmission of the main circuit of high-frequency isolated variable frequency speed regulation in mine. The input three-phase power frequency AC power supply is rectified into DC power supply through an uncontrollable rectification link. The pulsating DC power supply is smoothed and filtered to obtain a stable DC power supply. The DC power supply is transformed through high-frequency isolation (DC-DClevel). Then, through the three-phase inverter stage, the DC power supply is converted into AC power supply with adjustable voltage and frequency. In order to reduce IGBT switching loss, save the overall cost and reduce the complexity of its overall structure, the three-phase rectifier stage adopts a diode uncontrolled rectification strategy. The equal pulse width modulation (EPWM) strategy is adopted for the high-frequency isolated DC-DC stage. The speed sensorless vector control strategy is adopted in the three-phase inverter stage. In this control strategy, the model reference adaptive system (MRAS) is used to estimate the speed of the asynchronous motor. A 0.75 kW three-phase asynchronous motor is used as the tested motor to verify the speed sensorless vector control strategy of high-frequency isolated variable frequency speed regulation for mine. The results show the following points. ① The voltage fluctuation of the DC bus on both sides of the high-frequency isolation DC-DC level is less than 10 V and the high-frequency square wave voltage is equal. The voltage waveforms of the primary single-phase inverter square wave and the high-frequency transformer coupled square wave are smooth and the overall steady-state performance is good. ② The three-phase inverter voltage and current waveform sine degree are good. The waveform is symmetrical and smooth. The three-phase inverter level stability performance is good, which meets the requirements of motor operation. ③ With the increase of time, the excitation current change is stable. The torque current responds quickly at startup. The torque current is large at the start-up stage, which can generate large torque. ④ The speed fluctuation of the motor is small in the stable phase. The waveforms of acceleration and deceleration phases tend to be a linear function, and the motor can start and stop smoothly. When the motor is just started, the maximum torque can reach more than 5 times of the stable torque, and the motor can be started quickly to work. -
表 1 三相异步电动机参数
Table 1. Parameters of three-phase asynchronous motor
参数 数值 额定功率/kW 0.750 额定转速/(r·min−1) 1 390 满载电流/A 2.000 磁通互感量/mH 5.000 定子电感/mH 5.321 表 2 矿用高频隔离型变频器参数
Table 2. Mine frequency converter parameters of high frequency isolation type
参数 数值 三相输入电抗器电感/mH 5.00 DC−DC变换器原边稳压电容/μF 15.91 DC−DC变换器副边稳压电容/μF 14.88 高频变压器变比 1 辅助电感/H 36.00 LC滤波器电容/μF 4.70 LC滤波器电感/mH 3.00 电动机加减速时间/s 10.00 -
[1] MACHADO L,SOUSA T,PEDROSA D,et al. Experimental validation of a three-phase induction motor operating with a three-phase bidirectional variable speed drive[J]. EAI Endorsed Transactions on Energy Web,2021,8(34):168137. doi: 10.4108/eai.14-1-2021.168137 [2] SZYMANSKI J R,ZUREK-MORTKA M,ACHARJEE D. Unidirectional voltage converter for battery electric vehicle ultrafast charger[J]. Microsystem Technologies,2020,27:2865-2872. [3] 荣相. 矿用变频器性能测试系统设计[J]. 工矿自动化,2021,47(5):9-15. doi: 10.13272/j.issn.1671-251x.17671RONG Xiang. Design of mine inverter performance test system[J]. Industry of Mine Automation,2021,47(5):9-15. doi: 10.13272/j.issn.1671-251x.17671 [4] 程红,于志超,王朋辉,等. 新一代高频隔离级联式中高压变频器的协调方式研究[J]. 煤炭工程,2020,52(7):147-151.CHENG Hong,YU Zhichao,WANG Penghui,et al. Coordination model of new-generation high-frequency isolated cascaded medium and high voltage inverters[J]. Coal Engineering,2020,52(7):147-151. [5] 张桂林,王毅颖,刘建功,等. 基于电力电子变压器隔离变压的复合矿用变频器[J]. 工矿自动化,2021,47(10):70-76.ZHANG Guilin,WANG Yiying,LIU Jiangong,et al. Mine inverter based on isolation and transformation of power electronic transformer[J]. Industry and Mine Automation,2021,47(10):70-76. [6] BISWAL A P, SATPATHY S. Vector control of 3-phase induction motor [C]. 1st Odisha International Conference on Electrical Power Engineering, Communication and Computing Technology (ODICON), Bhubaneswar, 2021: 1-4. [7] ZHAO Lu, GE Qiangxuan, ZHOU Zhida, et al. Research of high-power converter based on the wide band gap power semiconductor devices for rail transit electrical drive[C]. 1st Workshop on Wide Bandgap Power Devices and Applications in Asia (WiPDA Asia), Xi'an, 2019: 1-4. [8] 陈辉. 电压源型变频器电磁干扰分析[J]. 电气应用,2010,29(8):78-81.CHEN Hui. Analysis of electromagnetic interference of voltage source frequency converter[J]. Electrotechnical Application,2010,29(8):78-81. [9] 车海军,王亮亮,霍丽娇,等. 改进的无功功率模型参考自适应异步电机转速辨识[J]. 电机与控制学报,2017,21(10):40-46,53.CHE Haijun,WANG Liangliang,HUO Lijiao,et al. Improved reactive power model reference adaptive speed identification applying to induction motor[J]. Electric Machines and Control,2017,21(10):40-46,53. [10] 楼徐杰,肖飞,胡亮灯. 基于反电动势的多相感应电机MRAS控制策略优化[J]. 海军工程大学学报,2020,32(3):56-63. doi: 10.7495/j.issn.1009-3486.2020.03.010LOU Xujie,XIAO Fei,HU Liangdeng. Optimization of MRAS control strategy for multiphase induction motor based on back EMF[J]. Journal of Naval University of Engineering,2020,32(3):56-63. doi: 10.7495/j.issn.1009-3486.2020.03.010 [11] 朱光耀,罗湘运,李世军. 一种用于异步电机控制的新型速度辨识方法[J]. 控制工程,2016,23(7):1012-1015.ZHU Guangyao,LUO Xiangyun,LI Shijun. A modified speed identification method for controlling of induction motor[J]. Control Engineering of China,2016,23(7):1012-1015. [12] 张永昌, 张虎, 李正熙. 异步电机无速度传感器高性能控制技术[M]. 北京: 机械工业出版社, 2015.ZHANG Yongchang, ZHANG Hu, LI Zhengxi. Asynchronous motor without speed sensor high performance control technology[M]. Beijing: China Machine Press, 2015.